No Pool-Enable; Ports - Siemens SCALANCE XC-200 Configuration Manual

Network protocols
7.3 DHCP server
Further notes
You display the setting with the show ip dhcp-server pools command.
You disable the setting with the no pool-enable command.
7.3.3.7

no pool-enable

Description
With this command you specify that this IPv4 address band will not be used.
Note
Deleting DHCP server bindings
If you disable or delete an IPv4 address band or you switch the DHCP server off and on again,
the DHCP server bindings are deleted. You display the DHCP server bindings with the show
ip dhcp-server bindings command.
Requirement
You are in the DHCPPOOL configuration mode.
The command prompt is as follows:
cli(config-dhcp-pool-<ID>)#
Syntax
Call the command without parameter assignment:
no pool-enable
Result
The setting is disabled.
Further notes
You display the setting with the show ip dhcp-server pools command.
You enable the setting with the pool-enable command.
7.3.3.8

ports

Description
With this command you enable the ports via which the IPv4 addresses of an address band in
the local subnet are assigned.
300
SCALANCE XB-200/XC-200/XF-200BA/XP-200/XR-300WG Command Line Interface
Configuration Manual, 07/2017, C79000-G8976-C361-06