Commands In The Global Configuration Mode; Clear-All-Static-Unicast; Auto-Learn - Siemens SCALANCE XC-200 Configuration Manual

Result
The configuration of the interface for the learning of MAC entries is displayed.
11.4.2

Commands in the Global configuration mode

This section describes commands that you can call up in the Global configuration mode.
In Privileged EXEC mode, enter the configure terminal command to change to this mode.
Commands relating to other topics that can be called in the Global configuration mode can be
found in the relevant sections.
You exit the Global configuration mode with the end or exit command and are then in the
Privileged EXEC mode again.
11.4.2.1

clear-all-static-unicast

Description
With this command, you delete all static unicast MAC address entries from the MAC address
table.
Requirement
You are in the Global configuration mode.
The command prompt is as follows:
cli(config)#
Syntax
Call the command without parameters:
clear-all-static-unicast
Result
The static unicast MAC address entries are deleted from the MAC address table.
11.4.2.2

auto-learn

Description
With this command, you change to the AUTOLEARN mode.
SCALANCE XB-200/XC-200/XF-200BA/XP-200/XR-300WG Command Line Interface
Configuration Manual, 07/2017, C79000-G8976-C361-06
Security and authentication
11.4 Port Access Control List Locked Ports
519