Switchport Private-Vlan Mapping - Siemens SCALANCE XC-200 Configuration Manual

no switchport private-vlan host-association
Result
The configuration is deleted.
Further notes
You configure a host port with the switchport private-vlan host-association
command.
You display this setting and other information with the commands show vlan port
config, show vlan and show vlan private-vlan.
You configure the interface as a host port with the command.
6.1.3.14

switchport private-vlan mapping

Description
With this command, you configure a promiscuous port.
The following settings are made:
● The interface becomes an untagged member of the primary PVLAN and all secondary
PVLANs.
● With incoming untagged frames, the port VLAN-ID of the primary VLAN is set.
● Ingress filtering is enabled.
Requirement
● The interface is configured as a promiscuous port.
● You are in the Interface configuration mode.
The command prompt is:
cli(config-if-$$$)#
Syntax
Call up the command with the following parameters:
switchport private-vlan mapping <primary_vlan_id(1-4094)> [{add |
remove}] [<secondary_vlan_list>]
The parameters have the following meaning:
Parameter
primary_vlan_id
add
SCALANCE XB-200/XC-200/XF-200BA/XP-200/XR-300WG Command Line Interface
Configuration Manual, 07/2017, C79000-G8976-C361-06
Description
VLAN ID of the primary PVLAN
Adds secondary PVLANs.
Network structures
6.1 VLAN
Range of values / note
1 ... 4094
-
189