Commands In The Global Configuration Mode; Login Authentication - Siemens SCALANCE XC-200 Configuration Manual

cli#
Syntax
Call up the command with the following parameters:
show radius server [<ucast_addr>]
The parameters have the following meaning:
Parameter
ucast_addr
For information on names of addresses and interfaces, refer to the section "Addresses and
interface names (Page 36)".
If no parameters are specified, all configured RADIUS servers are displayed.
Result
The RADIUS server configuration is displayed.
11.2.2

Commands in the global configuration mode

This section describes commands that you can call up in the Global configuration mode.
In Privileged EXEC mode, enter the configure terminal command to change to this mode.
Commands relating to other topics that can be called in the Global configuration mode can be
found in the relevant sections.
You exit the Global configuration mode with the end or exit command and are then in the
Privileged EXEC mode again.
11.2.2.1

login authentication

Description
With this command, you enable authentication via a RADIUS server.
Requirement
You are in the Global configuration mode.
The command prompt is as follows:
cli(config)#
SCALANCE XB-200/XC-200/XF-200BA/XP-200/XR-300WG Command Line Interface
Configuration Manual, 07/2017, C79000-G8976-C361-06
Description
Value for an IPv4 unicast address
Security and authentication
11.2 RADIUS client
Range of values / note
Enter a valid unicast address
507