No Option - Siemens SCALANCE XC-200 Configuration Manual

Network protocols
7.3 DHCP server
cli(config-dhcp-pool-<ID>)#
Syntax
Call up the command with the following parameters:
option <option-code> value-string <dhcp-param>
The parameters have the following meaning:
Parameter
option-
code
dhcp-param
Result
The DHCP option is configured.
Further notes
You display the setting with the show ip dhcp-server pools command.
You delete the DHCP option with the no option command.
You configure the DHCP options 3 and 6 with the option (IP address) command.
You disable the IPv4 address band with the no pool-enable command.
7.3.3.5

no option

Description
With this command, you delete the DHCP option with the specified number.
Requirement
You are in the DHCPPOOL configuration mode.
The command prompt is as follows:
cli(config-dhcp-pool-<ID>)#
Syntax
Call up the command with the following parameters:
no option <option-code>
298
Description
Code of the DHCP option
Name of the file
SCALANCE XB-200/XC-200/XF-200BA/XP-200/XR-300WG Command Line Interface
Range of values / note
● 12 - Host name
● 66 - TFTP server
● 67 - Bootfile name
Enter the name in the string format.
Configuration Manual, 07/2017, C79000-G8976-C361-06