Commands In The Interface Configuration Mode; Poe Active - Siemens SCALANCE XC-200 Configuration Manual

Syntax
Call up the command with the following parameters:
no poe pse <integer (1-4)> usage
The parameter has the following meaning:
Parameter
integer
Result
The parameter "Usage Threshold" is reset to the default value.
3.5.3

Commands in the Interface Configuration mode

This section describes commands that you can call up in the interface configuration mode.
Depending on the Interface selected, various command sets are available.
In the Global configuration mode, enter the interface command to change to this mode.
Commands relating to other topics that can be called in the interface configuration mode can
be found in the relevant sections.
● If you exit the Interface configuration mode with the exit command, you return to the Global
configuration mode.
● If you exit the Interface configuration mode with the end command, you return to the
Privileged EXEC mode.
3.5.3.1

poe active

Description
With this command, you activate PoE for the interface in whose interface configuration mode
you are currently working.
Requirement
You are in the Interface Configuration mode of a PoE interface.
The command prompt is as follows:
cli(config-if-$$$)#
Syntax
Call the command without parameters:
poe active
SCALANCE XB-200/XC-200/XF-200BA/XP-200/XR-300WG Command Line Interface
Configuration Manual, 07/2017, C79000-G8976-C361-06
Description
Number of the PSE
Configuration
Range of values / note
1 ... 4
3.5 PoE
113