Vlan - Siemens SCALANCE XC-200 Configuration Manual

● You cannot configure the port type.
● Defined access rules must be valid for all VLANs: authorized-manager ip-source
Further notes
You can display the status of this function and other VLAN information with the show vlan
device info command.
6.1.6.2

vlan

Description
With this command, you change to the VLAN configuration mode.
Requirement
You are in the Global configuration mode.
The command prompt is as follows:
cli(config)#
Syntax
Call up the command with the following parameters:
vlan <vlan-id(1-4094)>
The parameter has the following meaning:
Parameter
vlan-id
Do not enter any leading zeros with the number of the VLAN.
Result
You are now in the VLAN configuration mode.
The command prompt is as follows:
cli(config-vlan-1)#
Further notes
You can display information about the VLAN with the show vlan device info command.
SCALANCE XB-200/XC-200/XF-200BA/XP-200/XR-300WG Command Line Interface
Configuration Manual, 07/2017, C79000-G8976-C361-06
Description
Number of the addressed VLAN
Network structures
6.1 VLAN
Range of values / note
1 ... 4094
In the transparent bridge mode on‐
ly VLAN 1 is available.
209