Mac-Address-Table Static Unicast - Siemens SCALANCE XC-200 Configuration Manual

The command prompt is as follows:
cli(config)#
Syntax
Call up the command with the following parameters:
no mac-address-table static multicast <aa:aa:aa:aa:aa:aa>
The parameter has the following meaning:
Parameter
aa:aa:aa:aa:aa:
aa
For information on names of addresses and interfaces, refer to the section "Addresses and
interface names (Page 36)".
If you do not select any parameters from the parameter list, the default value is used.
Result
The entry is deleted from the forwarding database.
Further notes
With the show dot1d mac-address-table static multicast command, you display
the list of configured entries.
With the mac-address-table static multicast command, you create an entry.
10.2.2.3

mac-address-table static unicast

Description
With this command, you generate a static unicast MAC address entry in the forwarding
database.
Requirement
You are in the Global configuration mode.
The command prompt is as follows:
cli(config)#
Syntax
Call up the command with the following parameters:
SCALANCE XB-200/XC-200/XF-200BA/XP-200/XR-300WG Command Line Interface
Configuration Manual, 07/2017, C79000-G8976-C361-06
Description
MAC address of the interface
Load control
10.2 Static MAC filtering
Range of values / note
-
467