Load control
10.1 Rate control
10.1
Rate control
This section describes commands for controlling and restricting the data transmission rate of
an interface.
10.1.1
The "show" commands
This section describes commands with which you display various settings.
10.1.1.1
show rate-limit output
Description
This command shows the packet rate for limiting the outgoing data stream of one or all
interfaces.
Requirement
You are in the User EXEC mode or in the Privileged EXEC mode.
The command prompt is as follows:
cli> or cli#
Syntax
Call up the command with the following parameters:
show rate-limit output[interface<interface-type><interface-id>]
The parameters have the following meaning:
Parameter
interface
interface-type
interface-id
For information on names of addresses and interfaces, refer to the section "Addresses and
interface names (Page 36)".
If you do not select any parameter from the parameter list, the entries are displayed for all
available interfaces.
Result
The entries are displayed.
454
Description
Keyword for a an interface description
Type or speed of the interface
Module no. and port no. of the interface
SCALANCE XB-200/XC-200/XF-200BA/XP-200/XR-300WG Command Line Interface
Range of values / note
-
Enter a valid interface.
Configuration Manual, 07/2017, C79000-G8976-C361-06