Ip Address - Siemens SCALANCE XC-200 Configuration Manual

7.1.3.2

ip address

Description
With this command, you assign an IP address.
Requirement
You are in the Interface Configuration mode of VLAN.
The command prompt is as follows:
cli(config-if-vlan-$$$)#
Syntax
Call up the command with the following parameters:
ip address <ip-address> {<subnet-mask>| / <prefix-length(0-32)>}
The parameter has the following meaning:
Parameter
ip-address
subnet-mask
prefix-length
For information on names of addresses and interfaces, refer to the section "Addresses and
interface names (Page 36)".
Result
The IP address is assigned.
Note
Effectiveness of the command
The command is effective immediately. If you configure the interface via which you access the
device, the connection will be lost!
Further notes
You delete the setting with the no ip address command.
SCALANCE XB-200/XC-200/XF-200BA/XP-200/XR-300WG Command Line Interface
Configuration Manual, 07/2017, C79000-G8976-C361-06
Description
IP address
Subnet mask
Decimal representation of the mask as
a number of "1" bits
Network protocols
7.1 IPv4 protocol
Range of values / note
Specify a valid IP address.
Enter a valid subnet mask.
0 ... 32
279