Show Ip Igmp Snooping Globals - Siemens SCALANCE XC-200 Configuration Manual

Layer 2 management protocols
8.2 IGMP snooping
Requirement
● IGMP snooping is enabled on the device
● You are in the User EXEC mode or in the Privileged EXEC mode.
The command prompt is:
cli> or cli#
Syntax
Call up the command with the following parameters:
show ip igmp snooping forwarding-database [Vlan<vlan id>]
The parameters have the following meaning:
Parameter
Vlan
vlan id
For information on names of addresses and interfaces, refer to the section "Addresses and
interface names (Page 36)".
Result
The multicast forwarding entries are displayed.
8.2.1.3

show ip igmp snooping globals

Description
This command shows an overview of the settings of IGMP snooping.
Requirement
You are in the User EXEC mode or in the Privileged EXEC mode.
The command prompt is as follows:
cli#
Syntax
Call the command without parameter assignment:
show ip igmp snooping globals
Result
The settings are displayed.
376
Description
Keyword for a VLAN connection
Number of the addressed VLAN
SCALANCE XB-200/XC-200/XF-200BA/XP-200/XR-300WG Command Line Interface
Range of values / note
-
1 ... 4094
Configuration Manual, 07/2017, C79000-G8976-C361-06