No Channel-Group - Siemens SCALANCE XC-200 Configuration Manual

Network structures
6.2 Link aggregation
Requirement
With the interface po <channel-group-id(1-8)> command, you have already
generated a logical interface for an Etherchannel.
You are in the Interface configuration mode.
The command prompt is as follows:
cli(config-if-$$$)#
Syntax
Call up the command with the following parameters:
channel-group <channel-group-number(1-8)> mode{on|active|passive}
The parameters have the following meaning:
Parameter
channel-group-
number
on
active
passive
Result
The Etherchannel is configured.
6.2.2.2

no channel-group

Description
With this command, you remove the interface from an Etherchannel.
Requirement
You are in the interface configuration mode.
The command prompt is as follows:
cli(config-if-$$$)#
Syntax
Call the command without parameters:
216
Description
Number of the Channel-Group
Adds the interface without LACP to a
Channel-Group.
This corresponds to manual bundling.
The negotiation of a connection via
LACP is started unconditionally
The negotiation of a connection via
LACP is started when an LACP packet
arrives from the connection partner
SCALANCE XB-200/XC-200/XF-200BA/XP-200/XR-300WG Command Line Interface
Range of values / note
1 ... 8
-
-
-
Configuration Manual, 07/2017, C79000-G8976-C361-06