Plug; Commands In The Plug Configuration Mode; Factoryclean - Siemens SCALANCE XC-200 Configuration Manual

4.1.2.1

plug

Description
With this command, you change to the Plug Configuration mode.
Requirement
You are in the Global Configuration mode.
The command prompt is as follows:
cli(config)#
Syntax
Call the command without parameters:
plug
Result
You are now in the Plug Configuration mode.
The command prompt is as follows:
cli(config-plug)#
Further notes
You exit the Plug Configuration mode with the end or exit command.
4.1.3

Commands in the Plug configuration mode

This section describes commands that you can call up in the Plug Configuration mode.
In the Global Configuration mode, enter the plug command to change to this mode.
● If you exit the Plug Configuration mode with the exit command, you return to the Global
Configuration mode.
● If you exit the Plug Configuration mode with the end command, you return to the Privileged
EXEC mode.
4.1.3.1

factoryclean

Description
With this command, you delete the device configuration stored on the PLUG.
SCALANCE XB-200/XC-200/XF-200BA/XP-200/XR-300WG Command Line Interface
Configuration Manual, 07/2017, C79000-G8976-C361-06
Functions specific to SCALANCE
4.1 PLUG
129