No Standby Connection-Name; Standby Force-Master - Siemens SCALANCE XC-200 Configuration Manual

Layer 2 management protocols
8.4 Ring redundancy and standby connection
8.4.6.5

no standby connection-name

Description
With this command, you delete the name of a standby connection.
Requirement
You are in the Redundancy Configuration mode.
The command prompt is as follows:
cli(config-red)#
Syntax
Call the command without parameters:
no standby connection-name
Result
The name of the standby connection is deleted.
8.4.6.6

standby force-master

Description
With this command, you enable the standby force-master function.
Requirement
● HRPis enabed
● You are in the Redundancy configuration mode.
The command prompt is:
cli(config-red)#
Syntax
Call the command without parameters:
standby force-master
Result
The standby force-master function is enabled.
404
SCALANCE XB-200/XC-200/XF-200BA/XP-200/XR-300WG Command Line Interface
Configuration Manual, 07/2017, C79000-G8976-C361-06