No Spanning-Tree Mst Hello-Time - Siemens SCALANCE XC-200 Configuration Manual

Network structures
6.3 Spanning Tree
The parameter has the following meaning:
Parameter
seconds
Result
The setting for the hello time is configured.
Further notes
You can reset the setting for the hello time to the default with the no spanning-tree mst
hello-time command.
You display this setting and other information with the commands that start with show
spanning tree ....
6.3.5.15

no spanning-tree mst hello-time

Description
With this command, you reset the hello time after which the bridge sends its configuration
BPDUs to the default value.
The default value is 2 seconds.
Requirement
You are in the interface configuration mode.
The command prompt is as follows:
cli(config-if-$$$)#
Syntax
Call the command without parameters:
no spanning-tree mst hello-time
Result
The setting for the hello time is reset to the default value.
Further notes
You can configure the setting for the hello time with the spanning-tree mst hello-
time command.
254
Description
Time after which the bridge sends its
configuration frames (BPDUs)
SCALANCE XB-200/XC-200/XF-200BA/XP-200/XR-300WG Command Line Interface
Range of values / note
1 ... 2
Default: 2
Configuration Manual, 07/2017, C79000-G8976-C361-06