No Ip Nat Service Portrange - Siemens SCALANCE XC-200 Configuration Manual

9.1.3.10

no ip nat service portrange

Description
With this command you delete static port translations (NAPT) for an interface with a port range.
Requirement
You are in the Interface configuration mode
The command prompt is as follows:
cli(config-if-$$)#
Syntax
Call up the command with the following parameters:
no ip nat service portrange <inside local ip> {tcp|udp|any} <inside
local start port no> <inside local end port no>
The parameters have the following meaning:
Parameter
inside local ip
Protocol
inside local
start port no
inside local end
port no
Result
The static port translation with a port range is deleted.
Further notes
You configure static port translations for an interface with a port range with the ip nat
service portrange command.
You configure static port translations with a service for an interface with the ip nat
service command.
You display the current configuration with the show ip nat service portrange
command.
SCALANCE XB-200/XC-200/XF-200BA/XP-200/XR-300WG Command Line Interface
Configuration Manual, 07/2017, C79000-G8976-C361-06
Description
Actual address of the device that is
reachable from external.
Protocol for which the port translation is
valid.
Start port that is assigned to the inside
local address.
End port that is assigned to the inside
local address.
Layer 3 functions
Range of values / note
Enter a valid IPv4 address.
● tcp
● udp
● any
-
-
9.1 NAT
447