Vlan; No Vlan - Siemens SCALANCE XC-200 Configuration Manual

Network structures

6.1 VLAN

6.1.2.5 vlan
Description
With this command, you create a VLAN on the device and change to the VLAN configuration
mode.
In the provider backbone bridge mode, this command is used to create user, service and
backbone VLANs.
Requirement
You are in the Global configuration mode.
The command prompt is as follows:
cli(config)#
Syntax
Call up the command with the following parameters:
vlan <vlan-id(1-4094)>
The parameter has the following meaning:
Parameter
vlan-id
Do not enter any leading zeros with the number of the VLAN.
Result
The VLAN is created.
You are now in the VLAN configuration mode.
The command prompt is as follows:
cli(config-vlan-$$$)#
Further notes
You delete the VLAN with the no vlan command.
You can display information about the VLAN with the show vlan command.
6.1.2.6

no vlan

Description
With this command, you delete a VLAN on the device.
176
Description
Number of the addressed VLAN
SCALANCE XB-200/XC-200/XF-200BA/XP-200/XR-300WG Command Line Interface
Range of values / note
1 ... 4094
Configuration Manual, 07/2017, C79000-G8976-C361-06