No Mac-Address-Table Static Multicast - Siemens SCALANCE XC-200 Configuration Manual

The parameters have the following meaning:
Parameter
aa:aa:aa:aa:aa:aa
vlan
vlan-id
interface
interface-type
0/a-b, 0/c,...
port-channel
forbidden-ports
For information on names of addresses and interfaces, refer to the section "Addresses and
interface names (Page 36)".
Result
The entry in the forwarding database is generated.
Further notes
With the show mac-address-table static multicast command, you display the list
of configured entries.
With the no mac-address-table static multicast command, you delete an entry.
8.6.2.2

no mac-address-table static multicast

Description
With this command, you delete a static multicast address.
Requirement
You are in the Global configuration mode.
The command prompt is as follows:
cli(config)#
Syntax
Call up the command with the following parameters:
no mac-address-table static multicast <aa:aa:aa:aa:aa:aa> vlan <vlan-
id(1-4094)>
SCALANCE XB-200/XC-200/XF-200BA/XP-200/XR-300WG Command Line Interface
Configuration Manual, 07/2017, C79000-G8976-C361-06
Description
MAC address of the interface
Keyword for a VLAN connection
Number of the addressed VLAN
Keyword for a an interface description
Type or speed of the interface
Module no. and port no. of the interface
Specifies the name of a port channel
Keyword for the interface description of
the blocked ports
Layer 2 management protocols
8.6 Multicast
Range of values / note
-
-
1 ... 4094
-
Enter a valid interface.
1-8
-
425