Mac-Address-Table Static Multicast - Siemens SCALANCE XC-200 Configuration Manual

8.6.4.1

mac-address-table static multicast

Description
With this command, you generate a static multicast MAC address entry in the forwarding
database.
Requirement
You are in the Global configuration mode.
The command prompt is as follows:
cli(config)#
Syntax
Call up the command with the following parameters:
mac-address-table static multicast <aa:aa:aa:aa:aa:aa>
The parameters have the following meaning:
Parameter
aa:aa:aa:aa:aa
:aa
interface
interface-type
interface-id
port-channel
forbidden-
ports
For information on names of addresses and interfaces, refer to the section "Addresses and
interface names (Page 36)".
If you do not select any parameters from the parameter list, the default value is used.
Result
The entry in the forwarding database is generated.
SCALANCE XB-200/XC-200/XF-200BA/XP-200/XR-300WG Command Line Interface
Configuration Manual, 07/2017, C79000-G8976-C361-06
interface ([<interface-type> <interface-id>]
[<interface-type> <interface-id>]
[port-channel <1-8>]])
[forbidden-ports ([<interface-type> <interface-id>]
Description
MAC address of the interface
Keyword for a an interface description
Type of interface
Module no. and port no. of the interface
Specifies the name of a port channel
Keyword for the interface description of the
blocked ports
[<interface-type> <interface-id>]
[port-channel <1-8>]])
Layer 2 management protocols
8.6 Multicast
Range of values / note
-
-
Specify a valid interface.
1-8
-
429