The parameters have the following meaning:
Parameter
idle
tcp
udp
Result
The time periods are reset.
Further notes
You delete the periods of time with the ip nat timeout command.
You display the current configuration with the command.
9.1.3
Commands in the Interface configuration mode
This section describes commands that you can call up in the interface configuration mode.
Depending on the Interface selected, various command sets are available.
In the Global configuration mode, enter the interface command to change to this mode.
Commands relating to other topics that can be called in the interface configuration mode can
be found in the relevant sections.
● If you exit the Interface configuration mode with the exit command, you return to the Global
configuration mode.
● If you exit the Interface configuration mode with the end command, you return to the
Privileged EXEC mode.
9.1.3.1
ip nat
Description
With this command, you enable NAT for the IP interface.
Requirement
You are in the Interface configuration mode
The command prompt is as follows:
cli(config-if-$$)#
SCALANCE XB-200/XC-200/XF-200BA/XP-200/XR-300WG Command Line Interface
Configuration Manual, 07/2017, C79000-G8976-C361-06
Description
Keyword for the time period of a xxxx con‐
nection
Keyword for the time period of a TCP con‐
nection
Keyword for the time period of a UDP con‐
nection
Layer 3 functions
9.1 NAT
Range of values / note
-
-
-
439