Commands In The Dhcppool Configuration Mode; Lease-Time - Siemens SCALANCE XC-200 Configuration Manual

Network protocols
7.3 DHCP server
Requirement
● The IPv4 address band is not enabled.
● You are in the Global configuration mode.
The command prompt is as follows:
cli(config)#
Syntax
Call up the command with the following parameters:
no ip dhcp-server pool <pool-id (1-24)>
The parameter has the following meaning:
Parameter
pool-id
Result
The required IPv4 address band is deleted.
Further notes
You create an IPv4 address band with the ip dhcp-server poolcommand.
7.3.3

Commands in the DHCPPOOL configuration mode

This section describes commands that you can call up in the DHCPPOOL Configuration mode.
In the Global Configuration mode, enter the ip dhcp-server pool command to change to
this mode.
● If you exit the DHCPPOOL Configuration mode with the exit command, you return to the
Global Configuration mode.
● If you exit the DHCPPOOL Configuration mode with the end command, you return to the
Privileged EXEC mode.
7.3.3.1

lease-time

Description
With this command, you specify how long the assigned IPv4 address remains valid. When half
the period of validity has elapsed. the DHCP client can extend the period of the assigned IPv4
address. When the entire time has elapsed, the DHCP client needs to request a new IPv4
address.
294
Description
ID of the addressed IPv4 address band
SCALANCE XB-200/XC-200/XF-200BA/XP-200/XR-300WG Command Line Interface
Range of values / note
1 ... 24
Configuration Manual, 07/2017, C79000-G8976-C361-06