Set-Interface - Siemens SCALANCE XC-200 Configuration Manual

Network protocols
7.3 DHCP server
The parameters have the following meaning:
Parameter
remote-id
circuit-id
Result
The assignment is canceled.
Further notes
With the relay-information command, you assign devices with a certain remote ID and
circuit IPv4 addresses from a specific address band.
You display the setting with the show ip dhcp relay information command.
You enable the IPv4 address band with the pool-enable command.
7.3.3.12

set-interface

Description
With this command, you specify the interface via which the IPv4 addresses are dynamically
assigned.
Note
Assignment of IP addresses
When assigning IP addresses from a local address band, the IPv4 address of the interface
must be located within the IPv4 address band. If this is not the case, the interface does not
assign any IPv4 addresses.
The IP address does not need to be within the IPv4 address band if relay agent information is
configured for the address band.
Requirement
You are in the DHCPPOOL configuration mode.
The command prompt is as follows:
cli(config-dhcp-pool-<ID>)#
Syntax
Call up the command with the following parameters:
304
Description
Remote ID of the device
Circuit ID of the device.
SCALANCE XB-200/XC-200/XF-200BA/XP-200/XR-300WG Command Line Interface
Range of values / note
Enter the remote ID of the de‐
vice.
Enter the circuit ID of the device.
Configuration Manual, 07/2017, C79000-G8976-C361-06