No Broadcast-Block; Duplex - Siemens SCALANCE XC-200 Configuration Manual

Configuration
3.1 System
3.1.10.4

no broadcast-block

Description
With this command, you disable the blocking of broadcast frames on an interface.
Requirement
You are in the Interface configuration mode.
The command prompt is as follows:
cli(config-if-$$$)#
Syntax
Call the command without parameter assignment:
no broadcast-block
Result
The blocking of broadcast frames is disabled.
Further notes
You enable the blocking of broadcast frames with the broadcast-block command.
3.1.10.5

duplex

Description
Electrical interfaces can be operated in full duplex mode or half duplex mode. The options here
depend on the connected device.
Optical connections are always operated in full duplex mode since they have a fiber for each
transmission direction.
With this command, you configure the duplex mode of an interface. The same mode must be
set for connected interfaces.
Requirement
● Autonegotiation is disabled.
● You are in the Interface configuration mode of an electrical interface.
The command prompt is as follows:
cli(config-if-$$$)#
78
SCALANCE XB-200/XC-200/XF-200BA/XP-200/XR-300WG Command Line Interface
Configuration Manual, 07/2017, C79000-G8976-C361-06