No Standby Force-Master; Standby Port - Siemens SCALANCE XC-200 Configuration Manual

Further notes
You disable the setting with the no standby force-master command.
You can display the status of this function and other information with the show ring-
redundancycommand.
8.4.6.7

no standby force-master

Description
With this command, you disable the standby force-master function.
Requirement
● HRPis enabed
● You are in the Redundancy configuration mode.
The command prompt is:
cli(config-red)#
Syntax
Call the command without parameters:
no standby force-master
Result
The standby force-master function is disabled.
Further notes
You enable the setting with the standby force-master command.
You can display the status of this function and other information with the show ring-
redundancycommand.
8.4.6.8

standby port

Description
With this command, you configure and enable the port for a standby connection on a device.
SCALANCE XB-200/XC-200/XF-200BA/XP-200/XR-300WG Command Line Interface
Configuration Manual, 07/2017, C79000-G8976-C361-06
Layer 2 management protocols
8.4 Ring redundancy and standby connection
405