No Poe Active; Poe Custom Maxpwr - Siemens SCALANCE XC-200 Configuration Manual

Configuration
3.5 PoE
Result
PoE is activated for the corresponding interface.
3.5.3.2

no poe active

Description
With this command, you deactivate PoE for the interface in whose interface configuration mode
you are currently working.
Requirement
You are in the Interface Configuration mode of a PoE interface.
The command prompt is as follows:
cli(config-if-$$$)#
Syntax
Call the command without parameters:
no poe active
Result
PoE is deactivated for the corresponding interface.
3.5.3.3

poe custom maxpwr

Description
With this command you set the maximum power that a port makes available to supply a
connected device.
This value is taken into account when the function is enabled with the poe custom maxpwr
active command.
Requirement
You are in the Interface Configuration mode of a PoE interface.
The command prompt is as follows:
cli(config-if-$$$)#
Syntax
Call up the command with the following parameter:
114
SCALANCE XB-200/XC-200/XF-200BA/XP-200/XR-300WG Command Line Interface
Configuration Manual, 07/2017, C79000-G8976-C361-06