No Loopd Port Reset - Siemens SCALANCE XC-200 Configuration Manual

Diagnostics
12.6 Loop detection
Result
The blocked port is enabled again.
Further notes
You disable the setting with the no loopd port reset command.
You can display the status of this function and other information with the show loopd
command.
See also
Addresses and interface names (Page 36)
12.6.3.4

no loopd port reset

Description
With this command, you disable the port reset for loop detection.
Requirement
● Loop detection is enabled
● You are in the Interface configuration mode.
The command prompt is:
cli(config-if-$$$)#
Syntax
Call the command without parameters:
no loopd port reset
Result
The port reset function is disabled.
Further notes
You enable the setting with the loopd port reset command.
You can display the status of this function and other information with the show loopd
command.
See also
Addresses and interface names (Page 36)
606
SCALANCE XB-200/XC-200/XF-200BA/XP-200/XR-300WG Command Line Interface
Configuration Manual, 07/2017, C79000-G8976-C361-06