Further notes
With the show dot1d mac-address-table static unicast command, you display the
list of configured entries.
With the no mac-address-table static unicast command, you delete an entry.
8.5.4.2
no mac-address-table static unicast
Description
With this command, you delete a static unicast MAC address entry from the forwarding
database.
Requirement
You are in the Global configuration mode.
The command prompt is as follows:
cli(config)#
Syntax
Call up the command with the following parameters:
no mac-address-table static unicast <aa:aa:aa:aa:aa:aa>
The parameters have the following meaning:
Parameter
aa:aa:aa:aa:aa:aa
For information on names of addresses and interfaces, refer to the section "Addresses and
interface names (Page 36)".
Result
The entry is deleted from the forwarding database.
Further notes
With the show dot1d mac-address-table static unicast command, you display the
list of configured entries.
With the mac-address-table static unicast command, you create an entry.
SCALANCE XB-200/XC-200/XF-200BA/XP-200/XR-300WG Command Line Interface
Configuration Manual, 07/2017, C79000-G8976-C361-06
Description
MAC address of the interface
Layer 2 management protocols
8.5 Unicast
Range of values / note
-
419