Qos-Trust-Mode - Siemens SCALANCE XC-200 Configuration Manual

10.5.3.11

qos-trust-mode

Description
With this command you can set the method according to which frames to be forwarded are
prioritized port by port.
Requirement
You are in the QOS configuration mode.
The command prompt is as follows:
cli(config-qos)#
Syntax
Call up the command with the following parameters:
qos-trust-mode interface <interface-type> <interface-id > {untrust|
cos|dscp|cos-dscp}
The parameters have the following meaning:
Parameter
interface
interface-type
interface-id
untrust
cos
SCALANCE XB-200/XC-200/XF-200BA/XP-200/XR-300WG Command Line Interface
Configuration Manual, 07/2017, C79000-G8976-C361-06
Description
Keyword for a an interface description
Type or speed of the interface
Module no. and port no. of the interface
The switch sorts the incoming frames into a queue according to the priori‐
tization of the receiving port.
If there is a DSCP value in the IP header, this is ignored. If a VLAN tag
exists, it is replaced by the priority value of the receiving port.
If an incoming frame contains a VLAN tag, the switch sorts it into a queue
according to this prioritization.
If the frame does not contain a VLAN tag, the switch sorts the frame into
a queue according to the prioritization of the receiving port.
If there is a DSCP value in the IP header, this is ignored.
Load control
10.5 Service classes
Range of values / note
-
Enter a valid interface.
-
Default setting with
PROFINET variants
493