Authorized-Manager Ip-Source - Siemens SCALANCE XC-200 Configuration Manual

Security and authentication
11.3 Management Access Control List
Syntax
Call the command without parameter assignment:
no authorized-manager
Result
The authorized manager is deactivated.
Further notes
You enable the function with the authorized-manager command.
11.3.2.3

authorized-manager ip-source

Description
With this command, you configure the interfaces and protocols via which an authorized
manager is allowed to access the device.
Requirement
You are in the Global configuration mode.
The command prompt is as follows:
cli(config)#
Syntax
Call up the command with the following parameters:
authorized-manager ip-source <ip-address>
The parameters have the following meaning:
Parameter
ip-address
subnet-mask
prefixlength
interface
514
[{<subnet-mask>|/<prefixlength(0-32)>}]
[interface[<interface-type><0/a-b,0/c,...>]
[<interface-type><0/a-b,0/c,...>]]
[vlan<a,b or a-b or a,b,c-d>]
[service[snmp][telnet][http][https][ssh]]
Description
Specifies the network or the IP address
for which the IP manager is authorized
Subnet mask that restricts the authori‐
zation
Decimal representation of the mask as
a number of "1" bits
Keyword for a an interface description
SCALANCE XB-200/XC-200/XF-200BA/XP-200/XR-300WG Command Line Interface
Range of values / note
Enter a valid IPv4 address or a
network.
Enter a valid mask.
0 ... 32
-
Configuration Manual, 07/2017, C79000-G8976-C361-06