Show Vlan Private-Vlan - Siemens SCALANCE XC-200 Configuration Manual

Network structures
6.1 VLAN
The command prompt is as follows:
cli> or cli#
Syntax
Call up the command with the following parameters:
show vlan port config[{port<interface-type><interface-id>}]
The parameters have the following meaning:
Parameter
port
interface-type
interface-id
For information on identifiers of addresses and interfaces, refer to the section "Addresses and
interface names (Page 36)".
If you do not select any parameter from the parameter list, the entries of all available interfaces
are displayed.
Result
The information about the ports is displayed.
6.1.1.11

show vlan private-vlan

Description
This command shows the specific information for all or for a selected private VLAN type.
Requirement
You are in the User EXEC mode or in the Privileged EXEC mode.
The command prompt is as follows:
cli> or cli#
Syntax
Call up the command with the following parameters:
show vlan private-vlan [{primary|isolated|community}]
170
Description
Keyword for a port
Type of interface
Module no. and port no. of the interface
SCALANCE XB-200/XC-200/XF-200BA/XP-200/XR-300WG Command Line Interface
Range of values / note
-
Enter a valid interface.
Configuration Manual, 07/2017, C79000-G8976-C361-06