No Switchport Ingress-Filter - Siemens SCALANCE XC-200 Configuration Manual

Load control
10.2 Static MAC filtering
Syntax
Call the command without parameters:
switchport ingress-filter
Result
The ingress filter is activated.
Further notes
You disable the filter with the no switchport ingress-filter command.
You can display the status of the ingress filter and other settings with the show vlan port
config command.
10.2.3.2

no switchport ingress-filter

Description
With this command, you disable the ingress filter.
Requirement
You are in the Interface configuration mode.
The command prompt is as follows:
cli(config-if-$$$)#
Syntax
Call the command without parameters:
no switchport ingress-filter
Result
The ingress filter is deactivated.
Further notes
You enable the filter with the switchport ingress-filter command.
You can display the status of the ingress filter and other settings with the show vlan port
config command.
470
SCALANCE XB-200/XC-200/XF-200BA/XP-200/XR-300WG Command Line Interface
Configuration Manual, 07/2017, C79000-G8976-C361-06