No Ip Nat Pool; Ip Nat Service - Siemens SCALANCE XC-200 Configuration Manual

9.1.3.6

no ip nat pool

Description
With this command, you delete a pool for dynamic address translations.
Requirement
You are in the Interface configuration mode
The command prompt is as follows:
cli(config-if-$$)#
Syntax
Call up the command with the following parameters:
no ip nat pool <inside global ip>
The parameter has the following meaning:
Parameter
inside global ip
Result
A pool is deleted.
Further notes
You configure a dynamic address translation with the ip nat pool command.
You display the current configuration with the show ip nat command.
9.1.3.7

ip nat service

Description
With this command you configure static port translations (NAPT) for an interface with a service.
Requirement
You are in the Interface configuration mode
The command prompt is as follows:
cli(config-if-$$)#
SCALANCE XB-200/XC-200/XF-200BA/XP-200/XR-300WG Command Line Interface
Configuration Manual, 07/2017, C79000-G8976-C361-06
Description
Start address for the dynamic assign‐
ment of addresses at which devices are
reachable from external.
Layer 3 functions
Range of values / note
Enter a valid IPv4 address.
9.1 NAT
443