Network - Siemens SCALANCE XC-200 Configuration Manual

Requirement
You are in the DHCPPOOL configuration mode.
The command prompt is as follows:
cli(config-dhcp-pool-<ID>)#
Syntax
Call up the command with the following parameters:
lease-time <seconds (60-31536000)>
The parameter has the following meaning:
Parameter
seconds
Result
The time is configured.
Further notes
You display the setting with the show ip dhcp-server pools command.
7.3.3.2

network

Description
With this command you configure the IPv4 address band from which the DHCP client receives
any IPv4 address.
Note
Assignment of IP addresses
When assigning IP addresses from a local address band, the IPv4 address of the interface
must be located within the IPv4 address band. If this is not the case, the interface does not
assign any IPv4 addresses.
The IP address does not need to be within the IPv4 address band if relay agent information is
configured for the address band.
Requirement
You are in the DHCPPOOL configuration mode.
The command prompt is as follows:
SCALANCE XB-200/XC-200/XF-200BA/XP-200/XR-300WG Command Line Interface
Configuration Manual, 07/2017, C79000-G8976-C361-06
Description
Time until renewal of the assigned
IPv4 address in seconds
Network protocols
7.3 DHCP server
Range of values / note
60 ... 31536000
295