Snmp User - Siemens SCALANCE XC-200 Configuration Manual

7.5.2.20

snmp user

Description
With this command, you configure the details of an SNMP user.
Requirement
You are in the Global configuration mode.
The command prompt is as follows:
cli(config)#
Syntax
Call up the command with the following parameters:
snmp user <UserName> [auth {md5|sha} <passwd> [priv DES <passwd>]]
The parameters have the following meaning:
Parameter
UserName
auth
passwd
priv DES
passwd
Storage type
If optional parameters are not specified when configuring an SNMP user, the default values
apply.
SCALANCE XB-200/XC-200/XF-200BA/XP-200/XR-300WG Command Line Interface
Configuration Manual, 07/2017, C79000-G8976-C361-06
[{volatile|nonvolatile}]
Description
Name of the user
Specifies that authentication takes
place and which algorithm is used
Password for authentication
Specifies that there is encryption.
Value for the password of the encryption max. 32 characters
Specifies whether the settings remain
following a restart.
Network protocols
7.5 SNMP
Range of values / note
max. 32 characters
● md5 (Message Digest 5)
● sha (Secure Hash Algorithm)
Default: No authentication
max. 32 characters
If you enter user passwords for
SNMPv3 via the CLI, you cannot
enter any special characters.
When using the WBM you can en‐
ter special characters in user pass‐
words for SNMPv3.
-
Default: No encryption
● volatile:
The default settings are used
after a restart.
● nonvolatile:
The saved settings are used
after a restart.
347