Ip Nat Napt; No Ip Nat Napt - Siemens SCALANCE XC-200 Configuration Manual

9.1.3.3

ip nat napt

Description
With this command, you enable NAPT for the selected IP interface.
Requirement
You are in the Interface configuration mode
The command prompt is as follows:
cli(config-if-$$)#
Syntax
Call the command without parameter assignment:
ip nat napt
Result
NAPT is activated for the selected IP interface.
Further notes
You disable NAPT for the selected IP interface with the no ip nat napt command.
You display the current configuration with the show ip nat summary command.
9.1.3.4

no ip nat napt

Description
With this command, you disable NAPT for the selected IP interface.
Requirement
You are in the Interface configuration mode
The command prompt is as follows:
cli(config-if-$$)#
Syntax
Call the command without parameter assignment:
no ip nat napt
SCALANCE XB-200/XC-200/XF-200BA/XP-200/XR-300WG Command Line Interface
Configuration Manual, 07/2017, C79000-G8976-C361-06
Layer 3 functions
9.1 NAT
441