Commands In The Loadsave Configuration Mode; Delete - Siemens SCALANCE XC-200 Configuration Manual

Syntax
Call the command without parameters:
loadsave
Result
You are now in the LOADSAVE configuration mode.
The command prompt is as follows:
cli(config-loadsave)#
Further notes
You exit the LOADSAVE configuration mode with the exit command.
3.2.6

Commands in the LOADSAVE configuration mode

This section describes commands that you can call up in the LOADSAVE configuration mode.
In the Global Configuration mode, enter the loadsave command to change to this mode.
You display the valid file types for the commands in the LOADSAVE Configuration mode with
the global command show loadsave tftp.
● If you exit the LOADSAVE configuration mode with the exitcommand, you return to the
Global Configuration mode.
● If you exit the LOADSAVE configuration mode with the end command, you return to the
Privileged EXEC mode.
For information on the file types , refer to this list (Page 90).
3.2.6.1

delete

Description
With this command, you call up the possible files or delete a specific file.
Requirement
You are in the LOADSAVE configuration mode.
The command prompt is as follows:
cli(config-loadsave)#
Syntax
Call up the command with the following parameters:
SCALANCE XB-200/XC-200/XF-200BA/XP-200/XR-300WG Command Line Interface
Configuration Manual, 07/2017, C79000-G8976-C361-06
Configuration
3.2 Load and Save
95