Show Fault Counter; Show Cabletest Interface - Siemens SCALANCE XC-200 Configuration Manual

Result
The content of the logbook is displayed.
12.1.3.7

show fault counter

Description
This command shows the number of errors since the last startup.
Requirement
You are in the User EXEC mode or in the Privileged EXEC mode.
The command prompt is as follows:
cli> or cli#
Syntax
Call the command without parameters:
show fault counter
Result
The number of faults is displayed.
Further notes
You reset the counter for the errors with the clear fault counter command.
12.1.3.8

show cabletest interface

Description
This command shows the result of the cable test of the interface.
Requirement
● The interface has no active data traffic.
● The cabletest interface function was used on the specified interface in the Global
configuration mode.
● You are in the User EXEC mode or in the Privileged EXEC mode.
The command prompt is:
cli> or cli#
SCALANCE XB-200/XC-200/XF-200BA/XP-200/XR-300WG Command Line Interface
Configuration Manual, 07/2017, C79000-G8976-C361-06
Diagnostics
12.1 Event and fault handling
547