Commands In The Global Configuration Mode; Mac-Address-Table Aging-Time - Siemens SCALANCE XC-200 Configuration Manual

Load control
10.3 Dynamic MAC aging
The command prompt is as follows:
cli> or cli#
Syntax
Call the command without parameters:
show mac-address-table aging-status
Result
The status of the MAC aging is displayed.
10.3.2

Commands in the global configuration mode

This section describes commands that you can call up in the Global configuration mode.
In Privileged EXEC mode, enter the configure terminal command to change to this mode.
Commands relating to other topics that can be called in the Global configuration mode can be
found in the relevant sections.
You exit the Global configuration mode with the end or exit command and are then in the
Privileged EXEC mode again.
10.3.2.1

mac-address-table aging-time

Description
With this command, you configure the aging of a dynamically learned entry in the MAC address
list.
Requirement
You are in the Global configuration mode.
The command prompt is as follows:
cli(config)#
Syntax
Call up the command with the following parameters:
mac-address-table aging-time <seconds(15-630)>
472
SCALANCE XB-200/XC-200/XF-200BA/XP-200/XR-300WG Command Line Interface
Configuration Manual, 07/2017, C79000-G8976-C361-06