6.1.4.12
no private-vlan association
Description
With this command you delete the link between secondary PVLANs and a primary PVLAN.
Requirement
● The interface is configured as a primary PVLAN.
● You are in the Interface configuration mode.
The command prompt is:
cli(config-if-$$$)#
Syntax
Call the command without parameter assignment:
no private-vlan association
Result
The secondary PVLANs are not assigned to the primary PVLAN.
Further notes
You assign secondary PVLANs to a primary PVLAN with the command private-vlan
association.
You display this setting with the command.
You configure a an interface as a primary PVLAN with the private-vlan command.
6.1.5
The "show" commands (Transparent Bridge)
This section describes commands with which you display various settings.
6.1.5.1
show dot1d mac-address-table
Description
This command shows the table with the static and dynamic unicast entries and the dynamic
multicast entries.
Requirement
You are in the Privileged EXEC mode.
SCALANCE XB-200/XC-200/XF-200BA/XP-200/XR-300WG Command Line Interface
Configuration Manual, 07/2017, C79000-G8976-C361-06
Network structures
6.1 VLAN
203