Storm-Control Level - Siemens SCALANCE XC-200 Configuration Manual

Load control
10.1 Rate control
Requirement
You are in the Interface configuration mode.
The command prompt is as follows:
cli(config-if-$$$)#
Syntax
Call up the command with the following parameters:
no storm-control{broadcast|multicast|dlf}
The parameters have the following meaning:
Parameter
broadcast
multicast
dlf
if you call up the function without parameters, it is disabled for all types of transmission.
Result
The storm control function is disabled.
Further notes
You enable the function with the storm-control command.
10.1.2.5

storm-control level

Description
With this command, you configure the value for the storm control function in Kbps.
Requirement
You are in the Interface configuration mode.
The command prompt is as follows:
cli(config-if-$$$)#
Syntax
Call up the command with the following parameters:
storm-control level <rate-value>
458
Description
Disables broadcast storm control
Disables multicast storm control
Disables unknown unicast storm control
SCALANCE XB-200/XC-200/XF-200BA/XP-200/XR-300WG Command Line Interface
Configuration Manual, 07/2017, C79000-G8976-C361-06