Layer 3 functions
9.1 NAT
ip nat {idle timeout <seconds (60-86400)> | {tcp | udp } timeout
<seconds (300-86400)>}
The parameters have the following meaning:
Parameter
idle timeout
seconds
tcp
udp
Result
The time periods are defined.
Further notes
You can reset the time periods to the default with the ip nat timeout command.
You display the current configuration with the command.
9.1.2.4
no ip nat timeout
Description
With this command you reset periods of time after which existing connections are deleted back
to the default value.
Requirement
You are in the Global Configuration mode.
The command prompt is as follows:
cli(config)#
Syntax
Call up the command with the following parameters:
no ip nat {idle | {tcp | udp } timeout
438
Description
Keyword for the time after which a xxxx con‐
nection is deleted
Value for the time in seconds
Keyword for the time after which a TCP con‐
nection is deleted
Keyword for the time after which a UDP con‐
nection is deleted
SCALANCE XB-200/XC-200/XF-200BA/XP-200/XR-300WG Command Line Interface
Range of values / note
-
For the parameter idle:
● 60 ... 86400
For the parameter udp:
● 300 ... 86400
-
-
Configuration Manual, 07/2017, C79000-G8976-C361-06