No Mac-Address-Table Static Multicast - Siemens SCALANCE XC-200 Configuration Manual

Layer 2 management protocols
8.6 Multicast
Further notes
With the show dot1d mac-address-table static multicast command, you display
the list of configured entries.
With the no mac-address-table static multicast command, you delete an entry.
8.6.4.2

no mac-address-table static multicast

Description
With this command, you delete a static multicast MAC address entry from the forwarding
database.
Requirement
You are in the Global configuration mode.
The command prompt is as follows:
cli(config)#
Syntax
Call up the command with the following parameters:
no mac-address-table static multicast <aa:aa:aa:aa:aa:aa>
The parameter has the following meaning:
Parameter
aa:aa:aa:aa:aa:
aa
For information on names of addresses and interfaces, refer to the section "Addresses and
interface names (Page 36)".
If you do not select any parameters from the parameter list, the default value is used.
Result
The entry is deleted from the forwarding database.
Further notes
With the show dot1d mac-address-table static multicast command, you display
the list of configured entries.
With the mac-address-table static multicast command, you create an entry.
430
Description
MAC address of the interface
SCALANCE XB-200/XC-200/XF-200BA/XP-200/XR-300WG Command Line Interface
Range of values / note
-
Configuration Manual, 07/2017, C79000-G8976-C361-06