Tftp Server - Siemens SCALANCE XC-200 Configuration Manual

Configuration
3.2 Load and Save
The parameters have the following meaning:
Parameter
showfiles
filetype
filetype
Result
The file types are displayed or the file is copied.
Further notes
You configure the name of the file with the tftp filename command.
With the "show loadsave files" command, you can display the file types.
3.2.6.7

tftp server

Description
With this command, you configure the access to a TFTP server.
Requirement
You are in the LOADSAVE configuration mode.
The command prompt is as follows:
cli(config-loadsave)#
Syntax
Call up the command with the following parameters:
tftp server ipv4 <ipv4-address>[port<tcp port(1-65535)>]
The parameters have the following meaning:
Parameter
ipv4
ipv4-address
port
tcp port
For information on identifiers of addresses and interfaces, refer to the section "Addresses and
interface names (Page 36)".
100
Description
Shows the available files
Keyword for a file type to be loaded
Name of the file type
Description
Keyword for an IPv4 address
Value for an IPv4 unicast address
Keyword for the port of the server via
which the TFTP connection runs
Number of the port
SCALANCE XB-200/XC-200/XF-200BA/XP-200/XR-300WG Command Line Interface
Range of values / note
-
-
max. 100 characters
Range of values / note
-
Enter a valid IPv4 unicast address.
-
1 ... 65535
Configuration Manual, 07/2017, C79000-G8976-C361-06