Dot1X Guest-Vlan Reset; Set Dot1X Guest-Vlan Mac-Addr Count - Siemens SCALANCE XC-200 Configuration Manual

Security and authentication
11.5 Port Based Network Access Control
Further notes
You configure the guest VLAN ID with the dot1x guest-vlan vlan-id command.
You display this setting and other information with the show dot1x command.
11.5.3.5

dot1x guest-vlan reset

Description
This command removes MAC addresses from the guest VLAN. If you specify a MAC address,
only this MAC address is removed from the guest VLAN. If you use this command without
parameters, all MAC addresses are removed from the guest VLAN.
Requirement
You are in the Interface configuration mode.
The command prompt is as follows:
cli(config-if-$$$)#
Syntax
Call up the command with the following parameters:
dot1x guest-vlan reset [mac <aa:aa:aa:aa:aa:aa>]
The parameter has the following meaning:
Parameter
mac
Result
The specified MAC address or all MAC addresses are no longer assigned to the guest VLAN.
11.5.3.6

set dot1x guest-vlan mac-addr count

Description
With this command, you specify how many MAC addresses can be authenticated on the port
at the same time.
Requirement
You are in the Interface configuration mode.
532
Description
Keyword for the MAC address
MAC address to be removed from the
guest VLAN.
SCALANCE XB-200/XC-200/XF-200BA/XP-200/XR-300WG Command Line Interface
Range of values / note
-
aa:aa:aa:aa:aa:aa
Configuration Manual, 07/2017, C79000-G8976-C361-06