Show Ip Dhcp-Server Pools; Commands In The Global Configuration Mode - Siemens SCALANCE XC-200 Configuration Manual

Result
The information is displayed.
7.3.1.2

show ip dhcp-server pools

Description
The command shows the DHCP server configuration of a specific IPv4 address band or all
IPv4 address bands.
Requirement
You are in the User EXEC mode or in the Privileged EXEC mode.
The command prompt is as follows:
cli> or cli#
Syntax
Call up the command with the following parameters:
show ip dhcp-server pools [pool-id (1-24)]
The parameter has the following meaning:
Parameter
pool-id
If no parameters are specified, the settings for all address bands are displayed.
Result
The configuration of the DHCP server is displayed.
7.3.2

Commands in the global configuration mode

This section describes commands that you can call up in the Global configuration mode.
In Privileged EXEC mode, enter the configure terminal command to change to this mode.
Commands relating to other topics that can be called in the Global configuration mode can be
found in the relevant sections.
You exit the Global configuration mode with the end or exit command and are then in the
Privileged EXEC mode again.
SCALANCE XB-200/XC-200/XF-200BA/XP-200/XR-300WG Command Line Interface
Configuration Manual, 07/2017, C79000-G8976-C361-06
Description
ID of the addressed IPv4 address
band
Range of values / note
1 ... 24
Network protocols
7.3 DHCP server
289