Requirement
You are in the Global configuration mode.
The command prompt is as follows:
cli(config)#
Syntax
Call up the command with the following parameters:
ip dhcp-server pool [{ <pool-id (1-24)> | [{ vlan <vlan-id (1-4094)>
| <interface-type> <interface-id> }]}]
The parameters have the following meaning:
Parameter
pool-id
vlan
vlan-id
interface-type
interface-id
For information on identifiers of addresses and interfaces, refer to the section "Addresses and
interface names (Page 36)".
Result
The ID of the addressed IPv4 address band is configured.
You are now in the DHCPPOOL configuration mode.
The command prompt is as follows:
cli(config-dhcp-pool-<ID>)#
Further notes
You exit the DHCPPOOL configuration mode with the exit command.
You delete the entry with the no ip dhcp-server pool command.
7.3.2.6
no ip dhcp-server pool
Description
With this command, you delete the required IPv4 address band.
SCALANCE XB-200/XC-200/XF-200BA/XP-200/XR-300WG Command Line Interface
Configuration Manual, 07/2017, C79000-G8976-C361-06
Description
ID of the addressed IPv4 address band
Keyword for a VLAN connection
Number of the addressed VLAN
Type of interface
Module no. and port no. of the interface
Network protocols
7.3 DHCP server
Range of values / note
1 ... 24
-
1 ... 4094
Specify a valid interface.
293