7.6.2.1
smtp-server
Description
With this command, you configure an entry for an SMTP server.
Requirement
You are in the EVENTS configuration mode.
The command prompt is as follows:
cli(config-events)#
Syntax
Call up the command with the following parameters:
smtp-server {ipv4 <ucast_addr>} <receiver mail-address>
The parameters have the following meaning:
Parameter
ipv4
ucast_addr
receiver mail-
address
For information on names of addresses and interfaces, refer to the section "Addresses and
interface names (Page 36)".
Result
An entry for the SMTP server is configured.
Further notes
You delete an SMTP server entry with the no smtp-server command.
7.6.2.2
no smtp-server
Description
With this command, you delete an SMTP server entry.
Requirement
You are in the EVENTS configuration mode.
The command prompt is as follows:
SCALANCE XB-200/XC-200/XF-200BA/XP-200/XR-300WG Command Line Interface
Configuration Manual, 07/2017, C79000-G8976-C361-06
Description
Keyword for an IPv4 address
Value for an IPv4 unicast address
Name of the recipient
Network protocols
7.6 SMTP client
Range of values
-
Enter a valid IPv4 unicast address.
max. 100 characters
353