Commands In The Global Configuration Mode; Ip Gateway - Siemens SCALANCE XC-200 Configuration Manual

Network protocols
7.1 IPv4 protocol
Syntax
Call up the command with the following parameters:
show dcp forwarding [port<interface-type><interface-id>]
The parameters have the following meaning:
Parameter
port
interface-type
interface-id
For information on names of addresses and interfaces, refer to the section "Addresses and
interface names (Page 36)".
Result
The overview of the DCP forwarding behavior is displayed.
7.1.2

Commands in the global configuration mode

This section describes commands that you can call up in the Global configuration mode.
In Privileged EXEC mode, enter the configure terminal command to change to this mode.
Commands relating to other topics that can be called in the Global configuration mode can be
found in the relevant sections.
You exit the Global configuration mode with the end or exit command and are then in the
Privileged EXEC mode again.
7.1.2.1

ip gateway

Description
With this command, you configure the default gateway.
Requirement
You are in the Global configuration mode.
The command prompt is as follows:
cli(config)#
Syntax
Call up the command with the following parameters:
ip gateway <gateway>
272
Description
Keyword for a an interface description
Type or speed of the interface
Module no. and port no. of the interface
SCALANCE XB-200/XC-200/XF-200BA/XP-200/XR-300WG Command Line Interface
Range of values / note
-
Enter a valid interface.
Configuration Manual, 07/2017, C79000-G8976-C361-06