No Relay-Information - Siemens SCALANCE XC-200 Configuration Manual

cli(config-dhcp-pool-<ID>)#
Syntax
Call up the command with the following parameters:
relay-information <remote-id> <circuit-id>
The parameters have the following meaning:
Parameter
remote-id
circuit-id
Result
Devices with a certain remote ID and circuit ID are assigned the IPv4 addresses from a specific
address band. Before the IPv4 address band can be used, it still needs to be activated.
Further notes
You cancel the assignment with the no relay-information command.
You display the setting with the show ip dhcp relay information command.
You enable the IPv4 address band with the pool-enable command.
7.3.3.11

no relay-information

Description
With this command you cancel the assignment of devices with a certain remote ID and circuit
ID to IPv4 addresses from a specific address band.
Requirement
You are in the DHCPPOOL configuration mode.
The command prompt is as follows:
cli(config-dhcp-pool-<ID>)#
Syntax
Call up the command with the following parameters:
no relay-information <remote-id> <circuit-id>
SCALANCE XB-200/XC-200/XF-200BA/XP-200/XR-300WG Command Line Interface
Configuration Manual, 07/2017, C79000-G8976-C361-06
Description
Remote ID of the device
Circuit ID of the device.
Network protocols
7.3 DHCP server
Range of values / note
Enter the remote ID of the de‐
vice.
Enter the circuit ID of the device.
303