Layer 2 management protocols
8.5 Unicast
The parameters have the following meaning:
Parameter
vlan
vlan-range
address
aa:aa:aa:aa:aa:aa
interface
interface-type
interface-id
For information on names of addresses and interfaces, refer to the section "Addresses and
interface names (Page 36)".
If you do not select any parameter from the parameter list, the entries are displayed for all
available interfaces.
Result
The entries of the MAC addresses table are displayed.
8.5.1.2
show mac-address-table dynamic unicast
Description
This command shows the table with the dynamic unicast MAC addresses assigned by the
device.
Requirement
You are in the User EXEC mode or in the Privileged EXEC mode.
The command prompt is as follows:
cli> or cli#
Syntax
Call up the command with the following parameters:
show mac-address-table dynamic unicast[vlan<vlan-range>]
410
Description
Keyword for a VLAN or VLAN range
Number of the addressed VLAN or
VLAN range
Keyword for a MAC address
MAC address
Keyword for a an interface description
Type or speed of the interface
Module no. and port no. of the interface
[address<aa:aa:aa:aa:aa:aa>][{interface<interface-type>
<interface-id>}]
SCALANCE XB-200/XC-200/XF-200BA/XP-200/XR-300WG Command Line Interface
Range of values / note
-
1 ... 4094
Enter the range limits with a hy‐
phen or a space.
-
-
-
Enter a valid interface.
Configuration Manual, 07/2017, C79000-G8976-C361-06